At long last, we are working on windows. We still have a few interior partitions to build and Plycem to hang, but I wanted to use the wide open work space in container 4 a bit longer before building those partitions.
I should insert a note here about a recent change in our plan. Way back when this was to be a two story house, we had plans for two bedrooms — one downstairs where our master bedroom is going to be now, and one upstairs that was going to be the master. When the price of containers went sky high and we changed to a one story house, we were going to make a guest bedroom in a detached 20-foot container. But the 20-footer was the same high price as the 40-footers, so our plan stagnated a bit, and we have been floundering with a new plan to have one bedroom in the house and someday add a second.
Both Cynthia and I were unsettled by this un-plan, but we thought that time would iron out the bugs, and it has. Our newest, new and improved plan is this: we will put two bedrooms, two baths, and the laundry in the space between 3 and 4 and in container 4. My shop has been moved to a detached building (yet to be built) at the end of the driveway.
So now, the two bedrooms and bathrooms need windows. The areas to get windows are:
- the big open wall between containers 3 and 4 in the master bedroom. This entire wall will be windows. More on this area later in another post.
- the clerestory windows in the high wall over container 4, and
- the walls in the two bedrooms
We’re starting with areas 2 and 3 first. Cynthia and I talked about where and what size we wanted the windows, and I made a materials list. I bought some two-inch square, one-sixteenth-inch thick square steel tubing to make window frames from. It comes in 20-foot lengths. Here it is on the material rack in container 1:
I also ordered some jalousie windows to be made to fit the steel frames. Although we are not big fans of the look of jalousies, they make a lot of sense here where the rain and saturated fog can blow sideways. You can have the windows open for air but still have protection from the rain. Most of the older Panamanian houses have jalousies, although the newer houses seem to be going to vinyl sliders.
Next, I took a sheet of 3/4″ plywood and cut it to the size of the 4’x6′ pane of glass that will sit above the jalousies. Actually, I cut the plywood 6′-3/16″ so that the glass will have a little wiggle room. I also drove a big-headed nail into the 4-foot width, leaving the nail head sticking out 3/16″, making the height of the opening 4′-3/16″, like this:
With this plywood jig, the frames will be the perfect size for a piece of glass 4’x6′ and absolutely square, ready to receive the glass without problems. Here is the plywood jig with the first window frame being welded together:
By the end of day one, here is what I have welded together:
The two frames on the left are for a window in the north wall in each bedroom. The top rectangle is for the large pane of glass, and the lower part of the frame is for two, 3-foot jalousies. I still have to weld the bottom pieces on these frames, but I need to cut another piece of plywood to use as a jig so the jalousies will fit.
The frame on the right side of the photo above will be for the security bars. We plan to use the same design as the front gate, minus the cat tail seed pods. We think that the seed pods would be too busy looking in the design. This frame will be overlaid and attached to the frame that holds the windows. More on that detail in another post.
In another post I will use my new oxy-acetylene torch to cut holes in the container walls and install the frames. Stay tuned.
Bonus photo: As I welded the corners of the window frames, flaming balls of steel flew off the welding rod and rolled onto the plywood, burning this pattern in the plywood: